LiteRider PTC_Owner’s Manual | Rev A_121911 |
IV. ASSEMBLY
Arm Installation
1.Loosen the arm width adjustment screw from the arm receiver tube at the bottom rear of the seat frame with a 4mm Allen wrench. See figure 5.
2.Insert the arm into the arm receiver tube, so that the arm pad faces toward the front of the unit.
Figure 5
3.Adjust the width of the arm.
4.Tighten the arm width adjustment screw to secure the arm in place.
5.Repeat steps 1 – 4 for the opposite side.
Seat Belt Installation (Optional Equipment)
1.Use a 4mm Allen wrench to remove the arm width adjustment screw from the arm receiver tube at the bottom rear of the seat frame. See figure 5.
2.Insert one of the screws provided with the seat belt through one of the seat belt anchors, reinsert the screw into the receiver tube, and tighten to secure.
3.Repeat steps 1 and 2 for the opposite side of the seat belt.
14
