Chapter 11 Change Card Settings
| Table |
| |
|
|
|
|
| Heading | Description | Options |
|
|
|
|
| Port | Port number | 1 – 16 for an |
|
|
| |
|
|
|
|
| Laser bias | Default (15 min/1 day): 150 percent | |
|
|
|
|
| Laser bias | Default (15 min/1 day): 50 percent | |
|
|
|
|
| Optical power | Default (15 min/1 day): 120 percent | |
|
|
|
|
| Optical power | Default (15 min/1 day): 80 percent | |
|
|
|
|
| Optical power | Default (15 min/1 day): 200 percent | |
|
|
|
|
| Optical power | Default (15 min/1 day): 50 percent | |
|
|
|
|
| Set OPR | Setting the optical power received (OPR) establishes the received power level as 100%. | |
|
| If the receiver power decreases, then the OPR percentage decreases to reflect the loss | |
|
| in receiver power. For example, if the receiver power decreases 3 dBm, the OPR | |
|
| decreases 50%. |
|
|
|
|
|
Step 10 Click Apply. |
|
|
Note See Chapter 7, “Manage Alarms,” for information about the Alarm Behavior tab, including alarm profiles and alarm suppression.
Stop. You have completed this procedure.
NTP-E105 Change an Optical Port to SDH
Purpose | This procedure provisions a port on an |
Tools/Equipment | None |
Prerequisite Procedures | None |
Required/As Needed | As needed |
Onsite/Remote | Onsite or remote |
Security Level | Provisioning or higher |
Step 1 Complete the
Step 2
Step 3 Click the Provisioning > Line tabs.
Step 4 In the Type field, specify the port and choose SDH.
Step 5 Click Apply.
| Cisco ONS 15600 Procedure Guide, R5.0 |
| February 2008 |