Chapter 11 Change Card Settings
Note If you need to remove the SFP, see the
Stop. You have completed this procedure.
NTP-E66 Modify Line and Status Thresholds for Optical Ports
Purpose | This procedure changes line settings (line type, coding, and length), line |
| status (in service or out of service), and performance monitoring thresholds |
| for |
Tools/Equipment | None |
Prerequisite Procedures | |
Required/As Needed | As needed |
Onsite/Remote | Onsite or remote |
Security | Provisioning or higher |
Step 1 Complete the
|
|
| Step 2 | Complete the | |||||
|
|
| Step 3 | On the shelf graphic, | |||||
|
|
| Step 4 | Click the Provisioning > Line tabs. (Click Provisioning > Optical > Line tabs for the ASAP card). | |||||
|
|
| Step 5 | As needed, provision the options in Table | |||||
|
|
|
| Table |
|
|
| ||
|
|
|
|
|
|
|
| ||
|
|
|
| Heading |
| Description | Options | ||
|
|
|
|
|
|
|
| ||
|
|
|
| Port # |
| Identifies the port number | • For an | ||
|
|
|
|
|
|
| • For an | ||
|
|
|
|
|
|
| • For an ASAP card: up to 16 ports, | ||
|
|
|
|
|
|
|
| denoted by 4PIO module followed by | |
|
|
|
|
|
|
|
| port number. (Example: | |
|
|
|
|
|
|
|
| denotes the third port on 4PIO | |
|
|
|
|
|
|
|
| Module 1.) | |
|
|
|
|
|
|
|
| ||
|
|
|
| Port Name |
| Provides the ability to assign the | |||
|
|
|
|
|
| specified port a name | alphanumeric/special characters (blank | ||
|
|
|
|
|
|
| by default) | ||
|
|
|
|
|
|
|
|
| |
|
|
|
| SF BER |
| Sets the signal fail bit error rate | • | ||
|
|
|
|
|
|
| • | ||
|
|
|
|
|
|
| • | ||
|
|
|
|
|
|
|
|
| |
|
|
| Cisco ONS 15600 Procedure Guide, R5.0 |
|
|
| |||
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| February 2008 |
|
|
|
|
|
|
|
|
|