Cisco Systems ONS 15600 manual 11-7

Chapter 11 Change Card Settings

NTP-E66 Modify Line and Status Thresholds for Optical Ports

Table 11-2	OC-N Card Line Settings (continued)
Heading		Description	Options
SD BER		Sets the signal degrade bit error rate	•	1E-5
			•	1E-6
			•	1E-7 (default)
			•	1E-8
			•	1E-9
Provides Sync		Indicates that the port has been	Read-only
		provisioned as a network element timing	•	Yes (checked)
		reference on another node (ONS 15600,
			•	No (unchecked)
		ONS 15454, or ONS 15327)
Send Do Not		When checked, sends a DUS (do not use)	•	Yes (checked)
Use		message on the S1 byte	•	No (unchecked; default)
BLSR Ext.		Chosen extended byte carries information	•	K3
Byte		that governs BLSR protection switches.	•	Z2
			•	E2
			•	F1
Admin State		Sets the port service state unless network	•	IS—Puts the port in-service. The
		conditions prevent the change.		port service state changes to IS-NR.
			• IS,AINS (default)—Puts the port in
				automatic in-service. The port
				service state changes to
				OOS-AU,AINS.
			•	OOS,DSBLD—Removes the port
				from service and disables it. The port
				service state changes to
				OOS-MA,DSBLD.
			• OOS,MT—Removes the port from
				service for maintenance. The port
				service state changes to
				OOS-MA,MT.
AINS Soak		Sets the automatic in-service soak period.	Duration of valid input signal, in hh.mm
			format, after which the card becomes in
			service (IS) automatically (0 to 48 hours,
			in 15-minute increments).
Type		Defines the port as SONET or SDH.	•	SONET (default)
		Enable Sync Msg and Send Do Not Use	•	SDH
		must be disabled before the port can be
		set to SDH.

	Cisco ONS 15600 Procedure Guide, R5.0
February 2008		11-7