Chapter 1 Cisco SB 106 Router Cabling and Setup

Try to Connect to a Website

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 16A international) is used on the phase conductors (all current-carrying conductors).

Warning This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.

Try to Connect to a Website

Log in to a PC that is connected to the router, open a web browser, and connect to a website. If you successfully access a website, you do not need to change the configuration and you have completed setup. If you cannot access a website, follow the steps in the “Configure the Router” section on page 1-8.

Configure the Router

Configure the router by following the instructions in the Cisco Router and Security Device Manager (SDM) Quick Start Guide. This document shows you how to connect your PC to your router and how to use SDM, a configuration tool that you run from your web browser.

Additional information about SDM is available at the following URL:

www.cisco.com/go/sdm

Click the Technical Documentation link to view release notes and other SDM documentation.

 

Cisco SB 106 Router Cabling and Setup

1-8

78-16773-01

Page 16
Image 16
Cisco Systems SB 106 quick start Try to Connect to a Website, Configure the Router