To establish a gigabit Ethernet connection using a miniGBIC port, you must install a MGBT1, MGBSX1, or MGBLH1 gigabit expansion module and use Category 5e cabling or fiber optic cabling. To establish a Fast Ethernet connection using a miniGBIC port, you must install a MFEFX1 (100BASE- FX) or MFELX1
NOTE On the SLM248G, SLM248P, SLM224G, and SLM224P switches, miniGBIC ports are shared with standard ports. If a miniGBIC port is used, the shared standard port on the switch cannot be used. The following table defines the shared port mapping of the switch.
Switch Model | miniGBIC Port | Standard Port |
|
|
|
SLM248G/P | miniGBIC 1 | Port G1 |
|
|
|
SLM248G/P | miniGBIC 2 | Port G2 |
|
|
|
SLM224G/P | miniGBIC 1 | Port G1 |
|
|
|
SLM224G/P | miniGBIC 2 | Port G2 |
|
|
|
LEDs and Ports Common to all Switch Models
System — (Green) Lights up to indicate that the switch is powered on. Blinks while the switch is performing a system
LNK/ACT — (Green) Lights up to indicate a functional network link through the corresponding port to an attached device. Blinks to indicate that the switch is actively sending or receiving data through that port.
Reset — Press and hold the Reset Button for less than ten seconds to reboot the switch. Press and hold the Reset Button for more than ten seconds to reset the switch’s settings to the factory defaults.
Ethernet
Cisco Small Business SLM Series Smart Switch Installation Guide | 3 |