Cisco Systems SLM248P, SLM248G, SLM2024, SLM2048 quick start Desktop Placement, Rack Mounting

•Ambient Temperature — To prevent the switch from overheating, do not operate it in an area that exceeds an ambient temperature of 104°F (40°C).

•Air Flow — Be sure that there is adequate air flow around the switch.

•Mechanical Loading — Be sure that the switch is level and stable to avoid any hazardous conditions.

•Reliable earthing — Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch circuit (e.g. use of power strips).

Desktop Placement

To place the switch on a desktop, do the following:

•Attach the rubber feet to the recessed areas on the bottom of the switch.

•Place the switch on a desktop near an AC power source.

•Keep enough ventilation space for the switch and check the environmental restrictions mentioned above.

•Connect the switch to network devices according to the installation instructions below in section 4, “Connecting the Equipment”.

Rack Mounting

You can mount the switch in any standard size, 19-inch (about 48 cm) wide rack. The switch requires 1 rack unit (RU) of space, which is 1.75 inches (44.45 mm) high.

CAUTION Do not overload the power outlet or circuit when installing multiple devices in a rack.

STEP 1 Place the switch on a hard, flat surface with the front panel facing you.

STEP 2 Attach a rack–mount bracket to one side of the switch with the supplied screws and secure the bracket tightly.

STEP 3 Follow the same steps to attach the other bracket to the opposite side.

STEP 4 After the brackets are attached to the switch, use suitable screws to securely attach the brackets to any standard 19-inch rack.

Cisco Small Business SLM Series Smart Switch Installation Guide 5