Table 1-6shows valid interface type designators for the SN 5428-2; Figure 1-24shows each interface location and interface name on the SN 5428-2.
Table 1-6 Interface Type Designators
Interface Type | Description |
| |
fc | Fibre Channel |
| |
ge | Gigabit Ethernet |
| |
Figure 1-24 SN 5428-2 Chassis-Slot Numbering
ge1 | ge2 | fc1 fc2 fc3 fc4 fc5 fc6 fc7 fc8 |
Where to Go Next
When you are ready to configure the SN 5428-2 software, proceed to one of the following chapters in this configuration guide according to your needs:
•Chapter 2, “First-TimeConfiguration”—For initial setup or after configuration has been reset to factory default configuration
•Chapter 3, “Configuring System Parameters”—Using the CLI for setting up and modifying system parameters
•Chapter 4, “Configuring for VLAN”—Using the CLI for setting up and modifying VLAN configurations
•Chapter 5, “Configuring Fibre Channel Interfaces”—Using the CLI for setting up and modifying FC interface and zoning configurations
•Chapter 6, “Configuring SCSI Routing” —Using the CLI for setting up and modifying SCSI routing configurations
•Chapter 7, “Configuring Transparent SCSI Routing” —Using the CLI for setting up and modifying transparent SCSI routing configurations
•Chapter 8, “Configuring FCIP” —Using the CLI for setting up and modifying FCIP configurations
•Chapter 9, “Configuring Authentication”—Using the CLI for setting up and modifying authentication configurations
Cisco SN 5428-2 Storage Router Software Configuration Guide