Kyocera KM-2540 manual Originals Supported by the Document Processor, Specifications

5Original eject table

6Original stopper

7Opening handle

Originals Supported by the Document Processor

The document processor supports the following types of originals.

Item	Specifications
Weight	45 g/m² to 160 g/m²
Size	Maximum 11 × 17" to Minimum 5 1/2 × 8 1/2"
	Maximum A3 to Minimum A5R
Capacity	Plain paper (80 g/m²), Colored paper, Recycled
	paper: 75 sheets (Mixed sized originals: 30 sheets)
	Thick paper (120 g/m²): 49 sheets
	Thick paper (160 g/m²): 37 sheets
	Art paper: 1 sheet
	High quality paper (110 g/m²): 54 sheets

Originals Not Supported by the Document Processor

Do not use the document processor for the following types of originals.

•Soft originals such as vinyl sheets

•Transparencies such as OHP film

•Carbon paper

•Originals with very slippery surfaces

•Originals with adhesive tape or glue

•Wet originals

•Originals with correction fluid which is not dried

•Irregularly shaped (non-rectangular) originals

•Originals with cut-out sections

•Crumpled paper

•Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam).

•Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the originals to jam).

How to Load Originals

IMPORTANT Before loading originals, be sure there are no originals left on the original eject table. Left originals may cause the new originals to jam.

1 Adjust the original width guides to the width of the originals.

2-16 Preparation for Usage