New CLI Commands
•clear debug: Removes an iSCSI trace capture from system memory.
•debug iscsitrace default: Sets the default iSCSI trace parameters.
•debug scsirouter target iscsitrace: Enables trace facilities for debugging iSCSI connections on a
•show debug iscsitrace defaults: Displays the default PDU and trace buffer size to be used for iSCSI tracing.
•slp enable: Enables Service Location Protocol (SLP) service on the storage router.
Modified CLI Commands
•fcip destination config: The usesack and pacingrate keywords were added, the idlepingdelay default was changed to 15, and the default TCP receive window (rxtcpwinsize) was increased to 1048576.
•restore system: The slp and rip keywords were added, and RIP settings were removed from the
•show debug scsisouter: The show debug scsirouter target iscsitrace command syntax was added
Limitations and Restrictions on SN 5428-2 Storage Router Clusters
This release includes the following restrictions on SN
•A cluster can be composed of up to two SN
•A cluster can support up to 12 SCSI routing instances.
•A cluster can support up to 100 iSCSI targets.
Caveats
Caveats describe unexpected behavior or defects in the specified SN
This document describes open and resolved severity 1 and 2 caveats and selected caveats of other severities, for release 3.5.1.
•The “Open Caveats” section lists caveats that are open in the current release and may be open in previous releases.
•The “Resolved Caveats” section lists caveats that are resolved in this release, but open in previous releases.
Within the sections, the caveats are sorted alphanumerically by caveat number.
Release Notes for Cisco SN
10 |
| |
|
