PIONEERPOS G24-LC Hardware Information Commands, +CBC, Battery Charger Connection, Vcc

Chapter 3: AT Commands Reference

Hardware Information

Hardware Information Commands

+CBC, Battery Charger Connection

This command enables a user to query the battery charger connection. The battery level is an avarage value, which is updated every 30 seconds

Command Type	Syntax	Response/Action
Read	+CBC	+CBC:<bcs>,<bcl>

The following table shows the +CBC parameters.

		Table 3-81: +CBC Parameters
<Parameter>			Description
<bcs>	Charger detection
	0	Charger not detected
	1	Charger detected
	Note: The G24-L input power source is connected via the battery
		pins.
<bcl>	Battery charge level:
		VCC, V	Battery Level
	>3.7		90%
	3.5-3.7		60%
	3.4-3.5		20%
	3.35-3.4		10%
	3.3-3.35		5%
	<3.3		0%

Note: The G24-L does not allow the detection of battery use. The power supply of the G24-L is connected via the battery pins. However, users can use this command to verify the level of the G24-L input power source.

Example

AT+CBC
+CBC: 0,60	//This example shows 0 (battery powered) with 60% power.

April 15, 2008 G24-L AT Commands Reference Manual 3-129