PIONEERPOS G24-LC manual 159 D*99 Parameters, Gprssc, Gprs Service Code Calledaddres, L2P

Chapter 3: AT Commands Reference

The following table shows the D*99 parameters.

		Table 3-159: D*99 Parameters
<Parameter>		Description
<GPRS_SC>	Digit string (value 99) which identifies a request to use GPRS.
(GPRS Service
Code)
<called_addres	String that identifies the called party in the address space applicable to the PDP. For
s>	communications software that does not support arbitrary characters in the dial string,
	a numeric equivalent may be used. Also, the comma character "," may be used as a
	substitute for the period character ".".
	For PDP type OSP:IHOSS, the following syntax may be used for
	<called_address>:[<host>][@[<port>][@
	[<protocol>]]] where <host>, <port> and <protocol> are defined in “+CGDCONT,
	Define PDP Context” on page 3-232.
	For communications software that does not support arbitrary characters in the dial
	string, a numeric value equivalent to the hostname may be used. However, this should
	be avoided if at all possible.
<L2P>	String variable which indicates the layer 2 protocol to be used.
	For communications software that does not support arbitrary characters in the dial
	string, the following numeric equivalents are used:
	0	NULL
	1	PPP
	2	PAD
	3	X25
	9	yyyy M-xxxx
	Other values are reserved and result in an ERROR response to the Set command.
	Note: V.250 (and certain communications software) do not permit arbitrary characters
	in the dial string. The <L2P> and <called_address> strings are therefore specified as
	containing digits (0-9) only.
<cid>:	Digit string which specifies a particular PDP context definition (See “+CGDCONT,
	Define PDP Context” on page 3-232).
Example
ATD*99		//Try connecting to GPRS according to the first <cid>, defined in
+CGDCONT

April 15, 2008 G24-L AT Commands Reference Manual 3-243