PIONEERPOS G24-LC Modem Configuration and Profile, Modem Register Commands, G24-L Response Format

Modem Configuration and Profile

Modem Configuration and Profile

Modem Register Commands

The G24-L holds certain data items in selected memory space, named Software Registers (S-registers) and Modem Registers. Some of these registers are used as bitmaps, where one register holds more than one data item.

All S-registers can be accessed using the S command, described in “S, Bit Map Registers” on page 3-194. Some registers can also be accessed using dedicated commands, detailed below.

V, G24-L Response Format

This command determines the response format of the data adapter and the contents of the header and trailer transmitted with the result codes and information responses. This command also determines whether the result codes are transmitted in a numeric or an alphabetic ("verbose") form. The text portion of information responses is not affected by this setting.

The following table shows the effect that setting this parameter has on the format of information text and result codes.

Table 3-126: Effects of Parameter Settings

V0	V1		Information Responses
<ATV0><cr><lf>	<ATV1><cr><lf>	0 - "OK"
		1	- "CONNECT"
<numeric	<verbose code><cr><lf>
		2	- "RING"
code><cr><if>
		3	- "NO CARRIER"
		4	- "ERROR"
		5	- "NO DIALTONE"
		6	- "BUSY"
		7	- "NO ANSWER"

Command Type	Syntax	Response/Action	Remarks
Set	ATV<value>	OK	The Set command sets the format of
		or:	information responses and result
		+CME ERROR: <err>	codes.
Read	ATV?	<current value>	The Read command reads the current
			setting of response format.
Test			The Test command for V is not
			defined, and therefore is not supported
			by the G24-L. The G24-L returns an
			error.

3-190 G24-L AT Commands Reference Manual April 15, 2008