PIONEERPOS G24-LC manual DL, Dial Last Number, DL Parameters, Command Detailed Description, Atdl

Call Control

atd>1;	//Speed dial from phonebook
OK
OK
ath
NO CARRIER
OK
atd>1	//Speed dial from phonebook
+CME ERROR:	//Invalid characters in dial string
atd>"Motorola Internal"
+CME ERROR:	//Invalid characters in dial string

For more examples, refer to “Call Control” on page 4-14and “Data Call” on page 4-18.

DL, Dial Last Number

The DL command places a data/voice call to the last number dialed. The call progress information (success/failure) is reported in the same way as for the Dial command. (Refer to “D, Dial Command”, page 3-11).

Command	Detailed Description
ATDL[;]	Initial Response - Last Number retrieved:
	ATDL: "DIAL DIGITS"
	2nd response - Data/Fax call connected CONNECT
	1st response - Voice call placement begins
	OK
	2nd response - Voice call connected OK

The following table shows the DL parameters.

	Table 3-6: DL Parameters
<Parameter>	Description
semicolon (;)	If the semicolon (;) is given, a voice call is originated to the last dialed number.
	If the semicolon (;) is not given, a Fax/Data call is originated.
	Note: The last dialed call type is irrelevant to the DL command.

3-14 G24-L AT Commands Reference Manual April 15, 2008