PIONEERPOS G24-L Description Min Value Max Value Default Value, S12, S14, S21, S22, S31, S36, S39

Chapter 3: AT Commands Reference

The following table shows the different S-registers and their associated values.

Sn	Description	Min Value	Max Value	Default Value
S0	Sets/gets number of rings before	0	255	0
	auto answer.
S2	Sets/gets escape code character.	0	255	43
S3	Sets/gets carriage return code	0	127	13
	character.
S4	Sets/gets line feed code character.	0	127	10
S5	Sets/gets command line editing	0	127	8
	character (backspace).
S7	Sets the number of seconds in	1	255	30
	which connection must be
	established before the call is
	disconnected.
S12	Sets/gets guard time (in units of	0	255	20
	50 msec) for the escape character
	during CSD connections
S14	Read-only. Holds values of En	—	—	170
	(in bit 1),
	Qn (in bit 2), Vn (in bit 3).
S21	Read-only. Holds values of &Dn	—	—	40
	(in bits 2, 3 and 4), &Cn (in bits 5
	and 6).
S22	Read-only. Holds values of Mn	—	—	134
	(in bits 2 and 3),
	Xn (in bits 4, 5 and 6)
S31	Read-only. Holds value of Wn (in	—	—	0
	bits 2 and 3).
S36	Sets/gets value of \Nn.	0	7	5
S39	Read-only. Holds value of &Kn	—	—	3
	(in bits 0, 1 and 2).
S40	Read-only. Holds value of \An	—	—	192
	(in bits 6 and 7).
S41	Read-only. Holds value of %Cn	—	—	3
	(in bits 0 and 1).

Note: S0 (Auto Answer) should work regardless of the DTR HW line state. This is a deviation from the ITU V. 25-ter standard.

April 15, 2008 G24-L AT Commands Reference Manual 3-195