PIONEERPOS G24-LC manual +MSCTS, Enable/Disable CTS During Wakeup Period, Command parameters

Chapter 3: AT Commands Reference

Table 3-137: Command parameters

<Parameter>		Description	Remarks
<delta>	Time interval between one burst of sent/received		This value is saved on power
	data to the other before the terminal enters sleep		down.
	mode.
	0	: Wakeup out feature isn't active. (default when
	+S100 set command is never used)
	1	- 255: Time in seconds.

Example

ats100?

001 OK ats100=0

OK ats100? 000 OK

+MSCTS, Enable/Disable CTS During Wakeup Period

This command defines the behavior of the CTS line when the G24-L is in normal mode (not Sleep mode).

The command configures the G24-L CTS line behavior always to follow the flow control requirements, or to follow it only if the terminal initiated a serial transmission session. This saves the terminal from following the CTS interrupt every time the G24-L exits Sleep mode for internal G24-L reasons (non-terminal communication related reasons).

Command	Syntax	Response/Action	Remarks
Type
Set	AT+MSCTS=<control>	OK	The Set command tells the G24-L
			whether to activate the CTS when the
			unit is awakening.
Read	AT+MSCTS?	+MSCTS: <current	The Read command returns the current
		control>	control value.
		OK
Test	AT+MSCTS=?	+MSCTS: (list of	The Test command returns the possible
		supported <control>)	control values.
		OK

April 15, 2008 G24-L AT Commands Reference Manual 3-205