PIONEERPOS G24-LC manual +CGACT, PDP Context Activate or Deactivate, 161 +CGACT Parameters

Chapter 3: AT Commands Reference

+CGACT, PDP Context Activate or Deactivate

This command activates/deactivates the specified PDP context(s).

Command
Type	Syntax	Response/Action	Remarks
Set	AT+CGACT=[<state>	OK	The Set command
	[,<cid>	or:	activates/deactivates the specified PDP
	[,<cid>[,]]]]	NO CARRIER	context(s). When the command is
			completed, the ME remains in V.25
		or:
			command state. If any PDP context is
		+CME ERROR: <err>	already in the requested state, the state
			for that context remains unchanged. If
			the requested state for any specified
			context cannot be achieved, an
			ERROR or +CME ERROR response is
			returned. Extended error responses are
			enabled by the +CMEE command. If
			the ME is not GPRS-attached when the
			activation form of the command is
			executed, the ME first performs a
			GPRS attach and them attempts to
			activate the specified contexts. If the
			attach fails, the ME responds with an
			ERROR or, if extended error responses
			are enabled, with the appropriate
			failure-to-attach error message.
Read	AT+CGACT?	+CGACT: <cid>,	The Read command returns the current
		<state>	activation states for all the defined
		<CR><LF>+CGACT:	PDP contexts.
		<cid>, <state>
		<CR><LF>+CGACT:
		<cid>, <state>
		OK
Test	AT+CGACT=?	+CGACT: (list of	The Test command requests
		supported <state>s)	informaton on the supported PDP
		OK	context activation states.
		or:
		+CME ERROR: <err>

The following table shows the +CGACT parameters.

		Table 3-161: +CGACT Parameters
<Parameter>		Description
<state>	Indicates the activation state of the context:
	0	Non-active
	1	Active
<cid>	1-3	A numeric parameter that specifies a particular PDP context definition

April 15, 2008 G24-L AT Commands Reference Manual 3-245