PIONEERPOS G24-LC manual 98 +MMAD Parameters

Chapter 3: AT Commands Reference

Command
Type	Syntax	Response/Action	Remarks
Unsolicited	AT+MMAD=<Conver		If <Report> value is - 3,
Messages	ter_number>		the report will be generated
			according to report interval
			value. If <Report interval>
	Case:		value was not set, there
			will be no messages, but
	*. Average calculation		you can ask for a solicited
	isn't active :	+MMAD:	message.
		<Converter_number>,
		<Converted_Value> OK
	*. Average calculation
	is active:	+MMAD:
		<Converter_number>, <Average>
		OK

The following table shows the +MMAD parameters.

Table 3-98: +MMAD Parameters

<Parameter>		Description	Range/Remark
<Converter	1-5Select the A2D converter.
Number>
<Report>	0	Unsolicited report is not active/ stop unsolicited report &	Optional for Average
	deactivate +MMAD operation.		calculation.
	1	Unsolicited report in active for all A2D conversion events.
	2	Unsolicited reports are active only for out off boundaries events.
	3	"Average report" - send periodic average.
<Rate>	1-255Select the time interval between two samples.		100mili - for average;
	Units:		sec-Otherwise.
	100 milli Sec - in case of average computation.		Mandatory for Average
	Seconds - in case of A/D sampling only.		calculation.
<low>,<High>	0,230 or 300,450 A decimal value represents the digital value.
	Low - The lowest boundary level of digital value.
	High - The Highest boundary level of digital value.
	Default value for converters 1-3 is 0,230.
	Default value for converter 5 is 300,450.
<Converted	A decimal value represents the returned digital value.
Value>	For converters 1-3 and 5, the returned value represent the input level
	multiplied by 100.
<Num_of_sam	2	- 255 The number of samples that are used for average calculation.	Mandatory for Average
ples>			calculation.
<Average_calc	1	- 255 For how long the average calculation will be active.	1- Default value if average is
_duration>	0	- Not active.	active.
	255 - Endless.		While not active = 0.
	1...254 - minutes.

April 15, 2008 G24-L AT Commands Reference Manual 3-151