PIONEERPOS G24-L +Cgsms, +Cmgs, +Mcsat, +Csq, +Crlp, +Creg, +Cgreg, +Cops, +Cpol, +Mfs, +Cbc

Chapter 1: Product Features

Table 1-1: AT Commands (Cont.)

AT Command	Description	Page
+CGSMS	This command handles the selection of the service or service	Page 3-109
	preference used by the G24-L to send mobile-originated SMS
	messages.
+CMGS	This command sends an SM from the G24-L to the network.	Page 3-110
+MCSAT	This command enables/disables/exercises SMS alert tone for an	Page 3-111
	arriving SMS.
Network
Network Commands
+CSQ	This command displays the signal strength received by the G24-L.	Page 3-117
+CRLP	This command displays the Radio Link Protocol parameters.	Page 3-118
+CREG	This command enables/disables the network status registration	Page 3-119
	unsolicited result code.
+CGREG	This command enables/disables the GPRS network status	Page 3-121
	registration unsolicited result code.
+COPS	This command enables accessing the network registration	Page 3-122
	information, as well as select and register the GSM network
	operator.
+CPOL	This command is used to edit the list of preferred operators located	Page 3-125
	in the SIM card.
+MFS	This command is used to determine how long the G24-L waits	Page 3-126
	before attempting to re-register after a registration attempt has failed
	and the G24-L is not registered.
Hardware Information
Hardware Information Commands
+CBC	This command queries the battery charger connection.	Page 3-129
+MBC	This command allows the battery charger to be managed	Page 3-130
	(start, stop or automatic manage) and get indication for the
	battery level (solicited or unsolicited reports).
+CBAUD	This command sets the baud rate.	Page 3-132
+IPR	This command is responsible for setting and saving the request baud	Page 3-133
	rate.
+MTDTR	This command checks and displays the physical current status of the	Page 3-134
	DTR pin of the RS232.
+MTCTS	This command sets the CTS pin of the RS232 to not active (high),	Page 3-135
	waits one second and then sets the CTS to active (low).
&K	This command configures the RTS/CTS flow control.	Page 3-135
&C	This command determines how the state of the DCD line relates to	Page 3-136
	the detection of the received line signal from the distant end.

April 15, 2008 G24-L AT Commands Reference Manual 1-19