PIONEERPOS G24-LC manual Advanced Audio Setup Commands, +MAPATH, Audio Path, 107 S96 Parameters

Chapter 3: AT Commands Reference

The following table shows the S96 parameters.

		Table 3-107: S96 Parameters
<Parameter>		Description
<n>	0	Disable echo canceling. Disable noise suppression
	1	Enable echo canceling. Enable noise suppression
Example
ATS96=1		//Enable echo canceling
OK
ATS96=4
+CME ERROR: <err>
ATS96?
001		//Echo canceling enabled
OK

Advanced Audio Setup Commands

This group of commands enables accessory devices to control certain audio aspects within the system.

+MAPATH, Audio Path

This command sets/requests the active input accessory, and the output accessory for each feature. For example, you can choose the headset mic to be active, the voice and keypad feedbacks to go to the speaker, and the alerts and rings to go to the alert speaker. On power up, the default path, mic, speaker and alert speaker are restored.

Note: +MAPATH cannot be used to set digital audio, but only to read it. In order to set the digital audio path, use +MADIGITAL. For more information, refer to section “+MADIGITAL, Analog/Digital Audio Switching” on page 3-170.

April 15, 2008 G24-L AT Commands Reference Manual 3-163