PIONEERPOS G24-LC manual 207 +MPING Command Parameters, Destination IP/hostname, Count

Chapter 3: AT Commands Reference

Command Type	Syntax	Response/Action	Remarks
Read	+MPING?	+MPING: <count>,	The read command
		<size>,<TTL>,	displays currently
		<TOS>,<TimeOut>	selected parameters
			values for +MPING
			set command. If ping
		OK	sending procedure is
			currently in process
			then user selected
			parameters for
			AT+MPING
			command will be
			displayed, otherwise
			default parameter
			values will be
			displayed.
Test	+MPING=?	+MPING: (List of supported	The test command
		<mode>s),(Range of <count>s),(Range	displays all supported
		of <size>s),(Range of <TTL>s),	parameters values for
		(Range of <TOS>s),( Range of	+MPING set
			command.
		<TimeOut>s)
		OK

The following table shows the +MPING command parameters.

Table 3-207: +MPING Command Parameters

<Parameter>	Description
<mode>	0 - Abort current ping request execution.
	1 - Launch new ping request.
	There is no default value - appropriate ERROR will be
	displayed if parameter is not supplied.
<"Destination IP/hostname">	Specifies the target machine (computer), which is
	identified either by IP address 4 octets long in dotted
	decimal notation or by host name of maximum 255 (not
	including double quotes) characters long in dotted
	notation. Each octet of IP address has valid value range
	of 0 to 255. Host names are not case sensitive and can
	contain alphabetic or numeric letters or the hyphen.
	There is no default value - appropriate ERROR will be
	displayed if parameter is not supplied.
<count>	Specifies a number of Internet Control Message
	Protocol (ICMP) Echo Request messages to send. Valid
	value range is from 1 to 255.
	Default value: 4
<size>	Specifies the length, in bytes, of the Data field in the
	Echo Request messages sent. The minimum size is 0.
	The maximum size is 1372.
	Default value: 32

April 15, 2008 G24-L AT Commands Reference Manual 3-293