PIONEERPOS G24-LC manual +MIPOPEN, Open a Socket UDP or TCP, 195 +MIPCALL Parameters, Apn

Chapter 3: AT Commands Reference

The following table shows the +MIPCALL parameters.

		Table 3-195: +MIPCALL Parameters
<Parameter>		Description
<status>	0	Disconnect
	1	Connected
"APN"	APN of service provider (in quotation marks). Contact your service provider for
	details.
"User name"	User name in provider server (in quotation marks). Contact your service provider for
	details.
"Password"	Password for provider server (in quotation marks). Contact your service provider for
	details.
Local	IP address given by server after PPP negotiation.
IP-address

Example

AT+MIPCALL=1,"internet","User1","Pswd"//Connecting the provider 'Orange' and getting an IP

+MIPCALL: "123.145.167.230"
AT+MIPCALL=0	//The terminal hangs up the link
OK

+MIPOPEN, Open a Socket (UDP or TCP)

This command causes the G24-L to initialize a new socket and open a connection with a remote side. Each socket allocates an accumulating buffer whose size is 1372 bytes.

Note: The +MIPOPEN command returns a +MIPSTAT unsolicited event if it fails, for example, if it was rejected by the remote side.

MIPxxx is a complete set of GPRS commands. This set should not be used with other GPRS commands, such as CGATT, CGACT, and so on.

Command Type	Syntax	Response/Action	Remarks
Set	+MIPOPEN=	OK
	<Socket ID>,	+MIPOPEN: <Socket ID>,<State>
	<Source Port>,	or:
	<"Destination
		ERROR: <err>
	Address">,
	<Destination
	Port>, <Protocol>

April 15, 2008 G24-L AT Commands Reference Manual 3-277