PIONEERPOS G24-LC manual +CLCC, List Current Calls, At+Clcc?, At+Clcc=?

Call Control

+CLCC, List Current Calls

This command displays a list of all current G24-L calls and their statuses, and also enables/disables the unsolicited indication of the call list. (If no calls are received, no information response is sent to the terminal).

If the command succeeds but no calls are available, no information response is sent to the terminal.

The maximum number of simultaneous multiparty calls is 5+1 (5 in active group and 1 on hold).

Command	Syntax	Response/Action	Remarks
Type
Set	AT+CLCC=<state>	OK	The Set command enables/disables
		or:	unsolicited indications.
		+CME ERROR: <err>
Execute	AT+CLCC	+CLCC: <idx>,<dir>,<call	The Execute command enables
		state>, <mode>,	the receiving of data about
		<mpty>[,<number>,<type>,	current calls.
		<alpha>]
		[<CR><LF>+ CLCC:
		<idx>,<dir>,<call state>,
		<mode>,<mpty>[,<number>
		,<type>,<alpha>]
		[…]]
		OK
Read	AT+CLCC?	+CLCC: <state>	The Read command returns the call
		OK	status.
		or:
		+CME ERROR <err>
Test	AT+CLCC=?	+CLCC: (List of supported
		<state>s)
		OK
		or:
		+CME ERROR <err>

3-40 G24-L AT Commands Reference Manual April 15, 2008