PIONEERPOS G24-LC manual +MIPCALL, Create a Wireless Link, +Mipcall=?, At+Mipcall?

GPRS

+MTKP: 1,0,"! YOUR RECHARGE OF TSH: 250.00 TO 0756706666 IS SUCCESSFUL"

AT+MTKA	// No other message should be display until this command sent.
+MTKP: 1,0,"Transaction successful!"
AT+MTKA	// No other message should be display until this command sent.

+MTKM: "VodaFASTA"

+MTKM: 96,5,Recharge,0

+MTKM: 97,5,Transfer,0

+MTKM: 98,5,Report,0

+MTKM: 99,5,Administration,0

+MTKM: 100,5,Exit,0

…

TCP/IP

+MIPCALL, Create a Wireless Link

This command sets up a PPP (Point to Point Protocol) connection with the GGSN (Gate GPRS Support Node), and returns a valid dynamic IP for the G24-L.

Note: The DCD line changes only to reflect the state change from command mode to data mode.

Command Type	Syntax	Response/Action
Set	+MIPCALL= <Operation> [<APN>,	OK
	[<User name>, <Password>]]	+MIPCALL: <"local IP address">
		or:
		ERROR: <err>
		+MIPCALL: 0
Read	+MIPCALL?	+MIPCALL: <status>[,<IP>]
Test	+MIPCALL=?	+MIPCALL: (list of supported
		<operation>s)

Note: The +MIPCALL command does not return the prompt to the terminal until the IP is received from the provider, or time out has occurred, therefore, no other commands can be issued in the meantime.

The +MIPCALL command does not have a general ABORT mechanism, therefore a command cannot be issued until the previous command ends.

Note: When a call exists the dynamic IP address will be returned.

For example:

AT+MIPCALL?

+MIPCALL: 1,"172.17.237.80"

3-276 G24-L AT Commands Reference Manual April 15, 2008