PIONEERPOS G24-LC manual +MAMUT, Input Devices Mute, Mamut Parameters

Audio

+MAMUT, Input Devices Mute

This command controls the muting/unmuting of all input paths (mic, headset mic or digital RX). Upon power up, all the devices are unmuted.

Command
Type	Syntax	Response/Action	Remarks
Set	+MAMUT=<accy>,	OK	The Set command mutes/unmutes
	<state>	or:	any input accessory or any
		+CME ERROR: <err>	combination of them.
Read	+MAMUT?	+MAMUT:<accy1>,<state>	The Read command returns the
		+MAMUT:<accy2>,<state>	current mute/unmute state of all the
		+MAMUT:<accy4>,<state>	input accessories.
		OK
Test	+MAMUT=?	+MAMUT:(<accy>	The Test command returns the mute
		range),(<state> range)	states available and the output
			accessories supported.

The following table shows the +MAMUT parameters.

Table 3-110: MAMUT Parameters

<Parameter>		Description
<accy> (1-7)	1	Mic
	2	Headset mic
	4	Digital RX
<state>	0	Unmute
	1	Mute

Example

AT+MAMUT=2,0	//Accy=2 (headset mic), state=0 (unmute)
OK
AT+MAMUT=5,1	//Accy=5 (mic + Digital RX), state=1 (mute)
OK
AT+MAMUT?
+MAMUT: 1,1	//Accy=1 (mic), state=1 (mute)
+MAMUT: 2,0	//Accy=2 (headset mic), state=0 (unmute)
+MAMUT: 4,1	//Accy=4 (Digital RX), state=1 (mute)
AT+MAMUT=?
+MAMUT: (1-7),(0,1)
OK

3-168 G24-L AT Commands Reference Manual April 15, 2008