PIONEERPOS G24-LC manual +MSDNS, Set DNS IP Address, 210 +MSDNS Parameters, DNS server IP

Chapter 3: AT Commands Reference

+MSDNS, Set DNS IP Address

This command set/read DNS (Domain Name Server) IP address (primary/secondary) for each socket. If the user doesn't specify DNS servers by AT+MSDNS, G24-L will use default DNS from NW. The defined value(s) will be saved during disconnect PDP context (can be used in next PDP context), but will reset after power cycle.

Command Type	Syntax	Response/Action	Remarks
Set	AT+MSDNS=[<Socket_id>[,	OK
	<Primary DNS server IP>	or:
	[,<Secondary DNS server	+CME ERROR: <err>
	IP>]]]
Read	AT+MSDNS?	+MSDNS: 1,<Primary DNS server
		IP>,< Secondary DNS server
		IP><CR><LF>
		+MSDNS: 2,<Primary DNS server
		IP>,< Secondary DNS server
		IP><CR><LF>
		+MSDNS: 3,<Primary DNS server
		IP>,< Secondary DNS server
		IP><CR><LF>
		+MSDNS: 4,<Primary DNS server
		IP>,< Secondary DNS server
		IP><CR><LF>
		+MSDNS: 5,<Primary DNS server
		IP>,< Secondary DNS server
		IP><CR><LF>
		<CR><LF>
		OK
Test	AT+MSDNS=?	+MSDNS: (List of supported
		<Socket_id>s),(<IP>),(<IP>)

The following table shows the +MSDNS parameters.

Table 3-210: +MSDNS Parameters
<Parameter>	Description
<Socket_id>	A unique number that identifies a connection (provided
	by the terminal application).
	0 - Invalid socket number
	1,2,3,4 - Valid socket number
	5 - Valid socket number dedicated to +MPING.
<Primary DNS server IP>, <Secondary	IP of the destination site in the format
DNS server IP>	"AAA.BBB.CCC.DDD". The range of each octant is
	0-255. The value can be written in 1, 2, or 3 digits.

April 15, 2008 G24-L AT Commands Reference Manual 3-299