PIONEERPOS G24-LC manual 13 +CLIR Parameters, +Clir?, +Clir=?, OK AT+CLIR? +CLIR 1,4 AT+CLIR=2

Call Control

Note: When a service is in state A, and the terminal wants to enable the CLI presentation (turn CLIR off) for a single call, it can do so using the ATD command. This does not change the Temporary mode state. This can also be done when the service is in state B and the terminal wants to disable the CLI presentation (turn CLIR on) for a single call.

Command	Syntax	Response/Action	Remarks
Type
Set	+CLIR=<n>	OK	The Set command instructs the G24-L to
			enable/disable CLI restriction for all MO
			calls.
Read	+CLIR?	+CLIR:<n>,<m>	The Read command returns the current
		OK	setting of CLIR on the network <m> and
			on the G24-L <n>.
Test	+CLIR=?	+CLIR: (list of supported	The Test command returns <n> values
		<n>s)	supported by the G24-L.

The following table shows the +CLIR parameters.

		Table 3-13: +CLIR Parameters
<Parameter>		Description
<n>	Adjustment for outgoing calls
	0	- Presentation indicator is used according to the subscription of the CLIR service
	1	- CLIR invocation
	2	- CLIR suppression
	The default is 2.
<m>	Subscriber CLIR service status in the network
	0	- CLIR not provisioned
	1	- CLIR provisioned in permanent mode
	2	- Unknown (for example, no network and so on)
	3	- CLIR Temporary mode presentation restricted (can be the default)
	4	- CLIR Temporary mode presentation allowed (can be the default)

Example

AT+CLIR=? +CLIR: (0,1,2)

OK AT+CLIR? +CLIR: 1,4 AT+CLIR=2

OK

atd054565195;//MO voice call

OK

(… calling …)

(… a G24-L that has 054565195 SIM and is CLIP enabled will receive the following on the terminal:

RING

+CLIP: "",128,,128,"",1

3-30 G24-L AT Commands Reference Manual April 15, 2008