PIONEERPOS G24-L 209 +MPINGSTAT Unsolicited Response Parameters, SentMessages, ReceivedMessages

Chapter 3: AT Commands Reference

The following table shows the +MPINGSTAT unsolicited response parameters.

Table 3-209: +MPINGSTAT Unsolicited Response Parameters

<Parameter>	Description
<status>	Specifies a status of ping request execution.
	Defined values:
	0 - The unsolicited response with this <status> will be
	sent to DTE upon completion of ping request. If ping
	request was aborted or socket connection was
	terminated for any reason, this unsolicited response will
	not be reported to DTE.
	1 - The unsolicited response with this <status> will be
	sent to DTE if no ICMP reply message was received
	within timeout.
	2 - The unsolicited response with this <status> will be
	sent to DTE if socket connection was terminated for
	any reason. This status essentially means that ping
	request execution was aborted.
	3 - Flow Control OFF. The unsolicited response with
	this <status> will be sent to DTE if phone doesn't have
	enough memory to process sending an Echo Request
	message.
	4 - Flow Control ON. The unsolicited response with
	this <status> will be sent to DTE if phone has enough
	memory to send an Echo Request message after flow
	control was OFF.
<"Destination IP">	Specifies the target machine (computer) for ping
	request, which is identified by IP address 4 octets long
	in dotted decimal notation. Each octet of IP address has
	valid value range of 0 to 255.
<SentMessages>	Specifies a total number of sent Echo Request
	messages.
<ReceivedMessages>	Specifies a total number of received Echo Reply
	messages corresponding to Echo Request messages.
<AvarageRTT>	Specifies average Round Trip Time (RTT) for this ping
	request. This value will be reported if and only if
	<ReceivedMessages> value is greater than zero.
	Calculation of this value comprises of accumulating all
	RTT values and dividing total accumulated RTT by
	<ReceivedMessages> value. Only an integral part of a
	result will be reported and any digits of a fraction part
	will be truncated.

April 15, 2008 G24-L AT Commands Reference Manual 3-297