PIONEERPOS G24-LC manual +CGQREQ, Quality of Service Profile Requested, At+Cgqreq?, At+Cgqreq=?

GPRS

Example

AT+CGQMIN=?

+CGQMIN: ("IP"),(0-3),(0-4),(0-5),(0-9),(0-18,31)

OK AT+CGQMIN? +CGQMIN: 1,2,4,3,9,10 +CGQMIN: 2,2,4,3,9,10 +CGQMIN: 3,2,4,3,9,10

OK

+CGQREQ, Quality of Service Profile (Requested)

This command enables the terminal to specify a Quality of Service Profile that is used when the ME sends an Activate PDP Context Request message to the network.

Command	Syntax	Response/Action	Remarks
Type
Set	AT+CGQREQ=[<cid>	OK	The Set command specifies a
	[,<precedence>	or:	profile for the context identified
	[,<delay>	+CME ERROR: <err>	by the (local) context
	[,<reliability.> [,<peak>		identification parameter, <cid>.
	[,<mean>]]]]]]		As this is the same parameter
			that is used in the +CGDCONT
			command, the +CGQREQ
			command is effectively an
			extension of the +CGDCONT
			command. The QoS profile
			consists of a number of
			parameters, each of which may
			be set to a separate value.
			A special form of the Set
			command, +CGQREQ= <cid>,
			causes the requested profile for
			context number <cid> to become
			undefined.
Read	AT+CGQREQ?	+CGQREQ: <cid>,	The Read command returns the
		<precedence>, <delay>,	current settings for each defined
		<reliability>, <peak>, <mean>	context.
		OK
		or:
		+CME ERROR: <err>
Test	AT+CGQREQ=?	+CGQREQ: <PDP_type>,	The Test command returns
		(list of supported	values supported as a compound
		<precedence>s), (list of	value. If the ME supports several
		supported <delay>s), (list of	PDP types, the parameter value
		supported <reliability>s), (list	ranges for each PDP type are
		of supported <peak>s), (list of	returned on a separate line.
		supported <mean>s)
		OK
		or:
		+CME ERROR: <err>

3-236 G24-L AT Commands Reference Manual April 15, 2008