PIONEERPOS G24-LC +MCWAKE, Gprs Coverage, 90 +MCWAKE Parameters, At+Mcwake?, At+Mcwake =?

Chapter 3: AT Commands Reference

+MCWAKE, GPRS Coverage

This command tells the G24-L whether to report on the status of the GPRS/GSM coverage. There are three possibilities:

•Do not report the status of the GPRS/GSM coverage.

•Report only when the GPRS/GSM coverage goes off.

•Report only when the GPRS/GSM coverage goes on.

Command Type	Syntax	Response/Action
Set	AT+MCWAKE=<param>	OK
Read	AT+MCWAKE?	+MCWAKE: <param>
		OK
Test	AT+MCWAKE =?	+MCWAKE: (list of supported
		<param>s)
		OK

The following table shows the +MCWAKE parameters.

		Table 3-90: +MCWAKE Parameters
<Parameter>		Description
<param>	0	Sends no indication.
	1	Sends an indication when GPRS/GSM coverage goes off.
	2	Sends an indication when GPRS/GSM coverage goes on.
	The default value is 2.

Example

AT+MCWAKE=0

OK AT+MCWAKE? +MCWAKE: 0

OK AT+MCWAKE=1

OK AT+MCWAKE=2

OK AT+MCWAKE=? +MCWAKE: (0,1,2)

OK

April 15, 2008 G24-L AT Commands Reference Manual 3-139