PIONEERPOS G24-LC 206 +MIPCONF Parameters, Parameter Description Socket, Retrnum, MinTO, MaxTO

GPRS

parameters before socket activation or when the socket is in active state. Configuration values will be stored in G24-L until power circle.

Command Type	Syntax	Response/Action	Remarks
Set	AT+MIPCONF=<	OK	The Set updates TCP
	socket>[,[<retr_n	or:	stack configuration
	um>],[<min_TO>	+CME ERROR: <err>	parameters.
	],[<max_TO>],[<
	max_close_delay>
	][,<is_nack_ind_r
	eq>]]
Read	+MIPCONF?	+MIPCONF:	The read command
		1,<retr_num>,<min_TO>,<max_TO>,	returns current
		<max_close_delay>,<is_nack_ind_req>	settings of TCP stack
		<CR><LF>	parameters.
		+MIPCONF:
		2,<retr_num>,<min_TO>,<max_TO>,
		<max_close_delay>,<is_nack_ind_req>
		<CR><LF>
		+MIPCONF:
		3,<retr_num>,<min_TO>,<max_TO>,
		<max_close_delay>,<is_nack_ind_req>
		<CR><LF>
		+MIPCONF:
		4,<retr_num>,<min_TO>,<max_TO>,
		<max_close_delay>,<is_nack_ind_req>
Test	+MIPCONF=?	+MIPCONF:	The Test command
		(1-4),(1-5),(1-10),(10-600),(1-75),(0-2)	returns the possible
			parameters values.
			Time values can be
			inserted with
			resolution of 100
			milliseconds.

The following table shows the +MIPCONF parameters.

	Table 3-206: +MIPCONF Parameters
Parameter	Description
< socket >	Number of configured TCP socket (1 to 4)
< retr_num >	Number of retransmissions (1 to 5)
< min_TO >	Bottom limit to retransmit timeout ( 100 ms to 1 sec.)
<max_TO>	Upper limit to retransmit timeout (1 sec. to 60 sec.)

3-290 G24-L AT Commands Reference Manual April 15, 2008