PIONEERPOS G24-LC manual Command Echo, Qn Parameters, En Parameters

Modem Configuration and Profile

The following table shows the Qn parameters.

Table 3-128: Qn Parameters

<Parameter>		Description
<value>	0	Transmit result codes.
	1	Suppress result codes.
	The default value is 0.

Example

ATQ0

OK

ATQ?

Q:0 OK ATQ4

ERROR

ATQ1	//No response because result codes are suppressed.
ATQ4	//No response because result codes are suppressed.

E, Command Echo

This command defines whether input characters are echoed to output. If so, these characters are echoed at the same rate, parity and format at which they were received.

Command Type	Syntax	Response/Action	Remarks
Set	ATE<value>	OK	The Set command sets whether or not
		or:	to echo characters.
		+CME ERROR: <err>
Read	ATE?	<current value>	The Read command reads the current
			setting for command echo.
Test			The Test command for E is not defined
			by ITU, and therefore is not supported
			by the G24-L. The G24-L returns an
			error.

The following table shows the E parameters.

		Table 3-129: En Parameters
<Parameter>		Description
<value>	0	Does not echo characters
	1	Echoes characters
	The default value is 0.

3-192 G24-L AT Commands Reference Manual April 15, 2008