PIONEERPOS G24-LC Mapping Table, +CBST setting Mapped value for mobile terminated call, Error

Call Control

The only +CBST parameter that needs mapping for mobile terminated calls is <speed>, as described in the table below. The V.110 protocol is replaced by the analog protocol regardless of the +CBST setting. All other parameters are set by the +CBST command.

Table 3-16: Mapping Table (V.34)

+CBST setting	Mapped value for mobile terminated call
0	autobauding
4	2400 bps (V.22bis)
6	4800 bps (V.32)
7	9600 bps (V.32)
14	14400 bps (V.34)
68	2400 bps (V.110 or X.31 flag stuffing)
70	4800 bps (V.110 or X.31 flag stuffing)
71	9600 bps (V.110 or X.31 flag stuffing)
75	14400 bps (V.110 or X.31 flag stuffing)

Note: CSNS has read-only access to CBST data.

+MDC, Selection of Desired Message to Be Displayed Upon Connection of a Voice Call

This AT command enables you to select the desired messages to be displayed upon connection of a voice call with a remote party. The OK and CONNECT messages are available.

Command Type	Syntax	Response/Action	Remarks
Set	+MDC=<mode>	OK	The Set command selects which of the
		or:	supported messages will be displayed
		ERROR	upon connection of a voice call.
			<mode> Command Parameters:
			0 - Display OK on voice call
			connection
			1 - Display CONNECT on voice call
			connection
			Default Values:
			Power Up - As previously saved in
			NVM FLEX bit
			0 - Before Set command is first used
Read	+MDC?	++MDC: <mode>	The Read command should return the
		OK	current selection of <mode>.
Test	+MDC=?	+MDC: (list of	The Test command returns the possible
		supported <mode>s)	<mode> values.
		OK

3-36 G24-L AT Commands Reference Manual April 15, 2008