PIONEERPOS G24-LC manual 36 +CPBW Parameters, Parameter Description Index, At+Cpbw=?

Chapter 3: AT Commands Reference

field already exists in the PB, the new record will update the old one. If the writing fails in a G24-L error, +CME ERROR: <err> is returned.

Note: The "FD" phone book supports single wild card characters (?) and prefixes of a number in the telephone number field. In cases of fixed dialing, these entries in the "FD" phone book define a group of permitted numbers.

Call indications related to a fixed dialing entry containing wild cards or only a prefix of a number do not display any <alpha> identifier.

Command	Syntax	Response/Action	Remarks
Type
Set	AT+CPBW=[<index>][,	OK
	<number>	or:
	[,<type>[,<text>]]]	+CME ERROR: <err>
Test	AT+CPBW=?	+CPBW: (list of	This command queries the
		supported	allowable command field and
		<index>s),[<nlength>],	sizes.
		(list of supported
		<type>s),[<tlength>]
		OK

The following table shows the +CPBW parameters.

	Table 3-36: +CPBW Parameters
<Parameter>	Description
<index>	Index for a given phone book entry
<number>	Phone number of a given entry
<type>	The address type of a phone number
	129 Use for local call
	145 Use “+” for international access code
	128 Unknown
	Note: "128" is used to represent an email address or a mailing list. In this case,
	<ph_type> can be used to further differentiate between the two.
<text>	Text identifier for a phone book entry, according to the character set as specified by
	command +CSCS.
<nlength>	The maximum size of a phone number, in digits. There is a limited number of PB
	records that can be stored with this length. The number of "long" PB records depends
	on the size of the SIM card EXT1 extension file. If the extension file is full, an
	attempt to store a new record with more than 20 digits returns an error.
<tlength>	The maximum number of characters in the <text> entry. This applies to GSM standard
	characters only. Non-GSM standard character sets and extended GSM characters
	require additional space in storage. In some cases, when using such characters the text
	cannot be stored. In this case, the G24-L returns a "text string too long"error.

April 15, 2008 G24-L AT Commands Reference Manual 3-65