PIONEERPOS G24-LC Sleep Mode Commands, Reset to Default Configuration, Z Parameters, ATZ0

Chapter 3: AT Commands Reference

Example

AT&F? &F: 0

OK

Z, Reset to Default Configuration

This command drops the current call, and resets the values to default configuration.

Command Type	Syntax	Response/Action	Remarks
Set	ATZ<value>	OK
		or:
		+CMS ERROR: <err>
Read			The Read command for Z is not
			defined, and therefore is not supported
			by the G24-L. The G24-L returns an
			error.
Test			The Test command for Z is not
			defined, and therefore is not
			supported by the G24-L. The
			G24-L returns an error.

The following table shows the Z parameters.

		Table 3-134: Z Parameters
<Parameter>		Description
<value>	0	Set to user profile 0
	1	Set to user profile 1
	The default value is 0.

Example

ATZ0

OK

Sleep Mode Commands

When the G24-L is connected using RS232 connection to external device, a sleep mechanism is available. In order to improve the power consumption, the G24-L supports a low-power consumption mode, called "Sleep mode". The G24-L has internal decision conditions for entering and exiting sleep mode. As the terminal and the G24-L operate in a combined system, and as the communication between the G24-L and the terminal must be reliable, there should be a mechanism agreed upon by both the G24-L and the terminal to co-ordinate their separate sleep mode entering and exiting sequences. The G24-L will not enter sleep mode unless the terminal

April 15, 2008 G24-L AT Commands Reference Manual 3-199