PIONEERPOS G24-LC S102, Set Delay Before Sending Data to the Terminal, 135 S24 Parameters

Chapter 3: AT Commands Reference

Command Type	Syntax	Response/Action	Remarks
Set	ATS24=[<value>]	OK	The Set command sets the amount of
			time, in seconds, the G24-L should
			wait before entering Sleep mode.
Read	ATS24?	<value>	The Read command returns the current
		OK	value.

The following table shows the S24 parameters.

		Table 3-135: S24 Parameters
<Parameter>		Description
<value>	Number of seconds (0 <= n <= 255)
	0	Disable Sleep mode
	>0	Enable Sleep mode
	The default value is 0.

Example

ATS24? <enter> 000

OK

ATS24=5 <enter>

OK

ATS24? <enter> 005

OK

(If there are no radio and UART activities, the G24-L will enter sleep mode in 5 seconds)

S102, Set Delay Before Sending Data to the Terminal

This command sets the value of the delay before sending data to the terminal. Before receiving data, the terminal connected to the G24-L will receive:

•Terminal Wakeup signal (the Wakeup Out Line (pin #26) state will be active low).

•A delay that is equal ATS102 value.

•Data (GPRS, CSD, AT commands' echo and results, unsolicited reports).

April 15, 2008 G24-L AT Commands Reference Manual 3-203