PIONEERPOS G24-LC manual +MCSAT, Motorola Control SMS Alert Tone, 71 +MCSAT Parameters, Dcsmask

Chapter 3: AT Commands Reference

If after aborting AT+CMGS command execution and before result of operation was reported by G24-L, a second AT+CMGS command is executed, then the result of the second AT+CMGS operation only will be reported by G24-L.

+MCSAT, Motorola Control SMS Alert Tone

This command enables/disables/exercises the SMS alert tone for an arriving SMS. It does not apply on Cell Broadcast SMS.

Command	Syntax	Response/Action	Remarks
Type
Set	+MCSAT=<mode>	OK	The Set command is used to:
	[,<dcs_mask>[,....]]	or:	• Suppress (mute) the voice notification
		+CME ERROR: <err>	(alert tone) of a specific incoming SMS,
			identified by the received <dcs_mask>s
			property
			• Enable voice notification (alert tone) of
			all incoming SMS events
			• Activate the current alert tone for an
			incoming SMS event
Read	+MCSAT?	+MCSAT:	The Read command returns the current
		<mode>[,<dcs_mask>[,	<mode> and current <dcs_mask>s.
		....]]
		OK
		or:
		+CME ERROR: <err>
Test	+MCSAT=?	+MCSAT: (list of	The Test command returns the possible
		supported <mode>s)	<mode> values.
		OK
		or:
		+CME ERROR: <err>

The following table shows the +MCSAT parameters.

		Table 3-71: +MCSAT Parameters
<Parameter>		Description
<mode>	0	Suppress alert tone
	1	Enable alert tone
	2	Play alert tone
	The default value at power-up is 1.
<dcs_mask>	SMS data coding-scheme mask. The format is an 8-bit information parameter. Each
	bit contains 0, 1, or X (ASCII character):
	0	Condition is met if the arriving SMS includes dcs with 0 in this position
	1	Condition is met if the arriving SMS includes dcs with 1 in this position
	X or x This bit is ignored from the dcs of the arriving SMS

April 15, 2008 G24-L AT Commands Reference Manual 3-111