PIONEERPOS G24-LC manual +MIOC, Motorola I/O Configure, At+Mrst Ok, + Mioc?

Hardware Information

Example

AT+MRST OK

// Result - G24-L module performs a power down

+MIOC, Motorola I/O Configure

This command defines the G24-L 8 GPIO pins data value. The feature is flex enabled or disabled. This command is a basic command.

The feature is active by default, however, changing the FLEX can eliminate it.

Note: Support of the GPIO pins comes instead of supporting the keypad of the Evaluation board.

Command
Type	Syntax	Response/Action	Remarks
Set	AT+MIOC=<Pin	OK	The set command defines the logic
	selection>,<Data vector>	or:	value of selected pins to high or low
		+CME ERROR: <err>	when pin is configured as output.
			The G24-L saves the new setting in
			flex. Only selected pins are affected.
			Set action is allowed only for pins
			configured as output.
			In case <Data vector> includes values
			of input pins, those values will be
			ignored. In case <pin selection>
			includes input pins, an error will be
			issued "Operation not allowed". No
			action will take place.
Read	+ MIOC?	+MIOC: <Data vector>	The read command returns the actual
			logical value of the 8 GPIO pins.
		OK
Test	+ MIOC=?	+MIOC: (list of	The test command returns the possible
		supported <Pin	ranges of <Pin selection>s and <Data
		selection>s),(list of	vector>s.
		supported <Data
		vector>s)
		OK
		or:
		+CME ERROR: <err>

3-144 G24-L AT Commands Reference Manual April 15, 2008