PIONEERPOS G24-LC manual 120 +CPIN Parameters, Sim Pin, Sim Puk, SIM PUK2

			Chapter 3: AT Commands Reference
Command
Type	Syntax	Response/Action	Remarks
Set	AT+CPIN=[<puk>	OK	The Set command sends the password to
	or <pin>],	or:	the G-LITE that is necessary before it can
	[<newpin>]	+CME ERROR: <err>	be operated (SIM PIN or SIM PUK). If
			there is no PIN request pending, no action
			is taken towards the G-LITE, and an error
			message, +CME ERROR, is returned to
			the terminal.
			The Set command issued gives the code
			(SIM PIN or SIM PUK) corresponding to
			the error code required or returned as the
			result of the Read command. For example,
			if the SIM PIN is blocked, the error code
			11 or "SIM PIN required" is returned. The
			user must then issue the Set command with
			the SIM PIN.
Read	AT+CPIN?	+CPIN: <code>	The Read command returns an
		OK	alphanumeric string indicating the status
		or:	of the SIM card, and whether a password is
			required or not. This is an independent
		+CME ERROR: <err>
			SIM card lock status check only, and does
			not check the phone lock status.
Test	AT+CPIN=?	OK
		or:
		+CME ERROR: <err>

The following table shows the +CPIN parameters.

	Table 3-120: +CPIN Parameters
<Parameter>	Description
<puk>	PUK code for unblocking a blocked phone
<pin>	Current PIN for unlocking a locked phone
<newpin>	New PIN (after changing or after entering PUK) 4 - 8 digits
<code>	READY - Not waiting for a password
	SIM PIN - Waiting for SIM PIN
	SIM PUK - Waiting for SIM PUK
	SIM PIN2 - Waiting for SIM PIN, this response is given when the last executed
	command resulted in PIN2 authentication failure
	SIM PUK2 - Waiting for SIM PUK2, this response is given when the last executed
	command resulted in PUK2 authentication failure
SIM PIN	AT+CPIN=<pin>
SIM PUK	AT+CPIN=<puk>,<newpin>
SIM PUK2	AT+CPIN=<puk2>,<newpin2>
SIM PIN 2	AT+CPIN=<pin2>

April 15, 2008 G24-L AT Commands Reference Manual 3-179