PIONEERPOS G24-LC manual +MBC, Battery Charger, Hardware Information, At+Mbc?, At+Mbc=?

Hardware Information

OK

+MBC, Battery Charger

This command allows the battery charger to be managed (start, stop or automatic manage) and get indication for the battery level (solicited or unsolicited reports).

The Battery is external to the G24-L and connected via the 70 pin connector.

The values of the battery are: 3.2V-4.2V divided to 5 battery levels.

Notes:

•When the battery level is below the minimum, the G24-L will not power up untill the pre-chargelevel reaches the minimum level for activation.

•The G24-L will manage the charging process and algorithm when charging is enabled.

•The unsolicited reports will appear in the following cases (in case <Ind=1>):

1.Each time the level of the battery changes.

2.Inside the limits (3.2 and 4.2).

3.Charger connected/disconnected.

•The unsolicited report will appear even if the charger cable is not connected (only in case of <Ind=1>).

•ERRORS: Trying to start a charging process without a battery, error message of: NO BATTERY DETECTION will be received, for any other problems the following will be received: ERROR IN CHARGING PROCESS.

Command	Syntax	Response/Action	Remarks
Type
Set	AT+MBC=<Mode>,<	OK	The Set command sets the different
	Ind >	or:	mode (start, stop or automatic) and
		+CME ERROR: <err>	sets the report to be solicited or
			unsolicited.
Read	AT+MBC?	+MBC:	The Read command returns the current
		<Status>,<Batterylevel	status, battery level, mode and
		>,<Mode>,<Ind>	indication.
		OK
Test	AT+MBC=?	+MBC: (List of	The Test command returns the list of
		supported Mode),(List	supported modes and indications.
		of supported
		Indication)
		OK

3-130 G24-L AT Commands Reference Manual April 15, 2008