PIONEERPOS G24-L manual ATS97, Antenna Diagnostic, +MRST, Perform Hard Reset, 94 ATS97 Parameters

Chapter 3: AT Commands Reference

ATS97, Antenna Diagnostic

This command indicates whether an antenna is physically connected to the G24-L RF connector. This information is also provided by a dedicated hardware signal, which is outputted on pin 41 (ANT_DET) of the interface connector.

Command Type	Syntax	Response/Action	Remarks
Execute	ATS97	OK
		or:
		+CME ERROR: <err>
Read	ATS97?	<info>	The Read command indicates whether
		OK	the antenna is connected.
		or:
		+CME ERROR: <err>

The following table shows the ATS97 parameters.

		Table 3-94: ATS97 Parameters
<Parameter>		Description
<info>	000	The antenna is not connected
	001	The antenna is connected

Example

//Connect the antenna ATS97?

001

ATS97

OK ATS97=?

ERROR

//Disconnect the antenna ATS97?

000

+MRST, Perform Hard Reset

The +MRST command enables customer software to perform a hard reset to the G24-L unit.

Command Type	Syntax	Response/Action	Remarks
Set	+MRST	OK	The Set command performs a graceful
			hard reset to the G24-L module.
			Note: The Read and Test commands
			are not permitted for the
			+MRST command.

April 15, 2008 G24-L AT Commands Reference Manual 3-143