PIONEERPOS G24-LC Parameter Description Range/Remark Reportinterv, Average, AT+MMAD =1, AT+MMAD=1

Hardware Information

Table 3-98: +MMAD Parameters (Cont.)

<Parameter>	Description	Range/Remark
<Report_interv	0 - 255 Time interval between two averages reports (seconds).	0 - Default value.
al>
<Average>	Average calculation result.

Example

AT+MMAD =1	// Read A2D1 values with analog input of 1.75V.
+MMAD:1,175
OK
AT+MMAD=2,1,15	// Read A2D2 converted value every 15 seconds and send
OK	// unsolicited report to the DTE.
+MMAD: 2, 10	// Unsolicited Report after 15 seconds.
+MMAD: 2, 12	// Unsolicited Report after 30 seconds.
AT+MMAD= 3, 2,1,25,100	// Read A2D3 converted value every 1 second and send
OK	// unsolicited report if the converted value is out of boundaries.
+MMAD: 3,102	// Unsolicited report of value out of boundaries.
:
minutes, rate=5.	// Activate Average calcluation periodically every 30 sec, during 5
	// report originated by G24
duration=5	// Converter num=1, report=3, rate=5*100ms, low,high, N_samples,
AT+MMAD =1,3,5, , ,16,5,30
OK
+MMAD:1,175	//First report
+MMAD:1,140	//Second report
…..
+MMAD:1,160	//Last Avr report
AT+MMAD =1,0,5, , ,16,5,0	// Activate Average calcluation during 5 minutes, rate=5.
duration=5 min	// Converter num=1, report=0, rate=5*100ms, low,high, 16,
OK
AT+MMAD=1	//Only on explicit “AT+MMAD=<Converter_number>” command
OK

3-152 G24-L AT Commands Reference Manual April 15, 2008