PIONEERPOS G24-LC manual +CBST, Select Bearer Service Type, No Carrier OK AT+CLIR=0

Chapter 3: AT Commands Reference

RING

+CLIP: "",128,,128,"",1) ath

NO CARRIER OK AT+CLIR=0

OK

atd054565195;//MO voice call

OK

(… calling …)

(… a G24-L that has 054565195 SIM and is CLIP enabled will receive the following on the terminal:

RING

+CLIP: "054565006",129,,128,"",0

RING

+CLIP: "054565006",129,,128,"",0 …) ath

NO CARRIER OK

+CBST, Select Bearer Service Type

This command sets the GSM bearer service (data circuit duplex asynchronous and synchronous). It chooses one of the bearer services, the data rate of the service (actually the modulation when modem IWFs are used), and enables or disables the Radio Link Protocol.

Command	Syntax	Response/Action	Remarks
Type
Set	AT+CBST=[<speed>[,<	OK	The Set command selects the bearer
	name>	+CME ERROR: <err>	service <name> with data rate <speed>
	[,<ce>]]]		and the connection element <ce> to be
			used when data calls are originated
			(refer to GSM 02.02). Values may also
			be used during mobile terminated data
			call setup, especially in the case of
			single numbering scheme calls.
			Note: For incoming calls, the bearer
			service will be taken
			automatically from incoming
			parameters and not according
			to the CBST Set command.
			The G24-L does not change the output,
			but for incoming calls, the phone
			works in automatic mode.

April 15, 2008 G24-L AT Commands Reference Manual 3-31