PIONEERPOS G24-LC +Mcwake, +Mggind, +Cfun, +Icf, +Mrst, +Mioc, +Miod, +Mmad, +Mpcmc, +Crsl, +Clvl

AT Commands Summary

Table 1-1: AT Commands (Cont.)

AT Command	Description	Page
&D	This command determines how the G24-L responds when the DTR	Page 3-138
	(Data Terminal Ready) status is changed from ON to OFF during the
	online data state.
+MCWAKE	This command displays reports on the status of the GPRS/GSM	Page 3-139
	coverage.
+MGGIND	This command configures the service indicator on pin 49 of the 70	Page 3-140
	pin connector to be GPRS or GSM.
+CFUN	This command shuts down the phone functionality of smart phones	Page 3-141
	and PDAs with phone capabilities.
+ICF	This command determines the local serial port start/stop	Page 3-142
	(asynchronous) character framing used by the DCE when accepting
	DTE commands and transmitting information text and result codes.
S97	This command indicates whether an antenna is physically connected	Page 3-143
	to the G24-L RF connector.
+MRST	This command enables customer software to perform a hard reset to	Page 3-143
	the G24-L unit.
+MIOC	This command defines the G24-L 8 GPIO pins data value.	Page 3-144
+MIOD	This command defines the G24-L 8 GPIO pins configuration.	Page 3-147
+MMAD	This command reads and monitors digital value from a specified	Page 3-149
	ADC.
+MPCMC	This command defines whether the PCM clock is generated	Page 3-153
	continuously or not, when module is in digital audio mode.
Audio
Basic Audio Setup Commands
+CRSL	This command handles the selection of the incoming call ringer and	Page 3-158
	alert tone (SMS) sound level on the alert speaker of the G24-L.
+CLVL	This command sets the volume of the internal loudspeaker (which	Page 3-159
	also affects the key feedback tone) of the G24-L.
+CMUT	This command mutes/unmutes the currently active microphone path	Page 3-160
	by overriding the current mute state.
S94	This S-parameter represents the Boolean status, On/Off, of the	Page 3-161
	sidetone feature.
S96	This S-parameter represents the Boolean status, On/Off, of the echo	Page 3-162
	cancelling feature in the handsfree.
Advanced Audio Setup Commands
+MAPATH	This command sets/requests the active input accessory, and the	Page 3-163
	output accessory for each feature.
+MAVOL	This command determines a volume setting for a particular feature	Page 3-166
	in a particular accessory.

1-20 G24-L AT Commands Reference Manual April 15, 2008