PIONEERPOS G24-LC manual +MIPRUDP, Receive Data from UDP Protocol Stack, Set Command Event

	Chapter 3: AT Commands Reference
Example
AT+MIPFLUSH=2	//Socket number 2 was previously opened using the +MIPOPEN
command
+MIPFLUSH: 2
OK
AT+MIPFLUSH=5
ERROR
AT+MIPFLUSH?
+MIPFLUSH: 1 2
OK

+MIPRUDP, Receive Data from UDP Protocol Stack

This unsolicited event is sent by the G24-L to the terminal when data is received from the UDP protocol stack.

Set Command Event

+MIPRUDP:<Source IP>,<Source Port><socket ID>,<Left>,<Data>

The following table shows the +MIPRUDP parameters.

	Table 3-203: +MIPRUDP Parameters
<Parameter>	Description
Source IP	IP of the source
Source Port	Port of the source
Socket ID	1,2,3,4 - Number of valid sockets.
Left	Size of received Data still left in protocol stack.
Data	Data string received with 0-F hexadecimal digits. String ends with a <CR>.

Example

+MIPRUDP: 172.16.3.135,222,2,0,44444444

+MIPRTCP, Receive Data from TCP Protocol Stack

This unsolicited event is sent by the G24-L to the terminal when data is received from the TCP protocol stack.

Set Command Event

+MIPRTCP: <socket ID>,<Left>,<Data>

April 15, 2008 G24-L AT Commands Reference Manual 3-287