PIONEERPOS G24-LC manual 15 +CSNS Parameters, Parameter Description Mode, Repeated

Chapter 3: AT Commands Reference

The following table shows the AT+CSNS parameters.

		Table 3-15: +CSNS Parameters
<Parameter>		Description
<mode>	CSNS mode:
	0	- Voice (default)
	2	- Fax (TS 62)
	4	- Data
<repeated>	Defines for how long to save the new setting:
	0	One shot (new setting is not saved)
	1	CSNS mode is saved until new +CSNS set command is issued or next power
		cycle, whichever occurs first.
	2	CSNS mode is saved until new +CSNS set command is issued. The CSNS
		mode will be stored in non-volatile memory and will be effective after power
		cycle.

Note: Any mobile-terminated call lacking bearer capability information is handled according to the current CSNS setting.

When <mode> is set to data service, the parameter values set with the +CBST command are used (Refer to “+CBST, Select Bearer Service Type” on page 3-31). If the +CBST parameter is set to a value that is not applicable to single numbering calls, the G24-L maps the value to the matching one, according to the Mapping Table (Table 3-16).

The <mode> selected in conjunction with <repeated> value ’2’ setting replaces <mode> setting in MS non-volatile memory of the bearer or teleservice to be used when mobile terminated single numbering scheme call is established. Selected <mode> is effective until new CSNS set command is issued. After power cycle, <mode> setting in MS non-volatile memory returns to be effective (<mode> selected in conjunction with <repeated> value ’2’ or default <mode>).

If CSNS set command is issued in conjunction with <repeated> value ’0’ (one shot), then selected <mode> is effective until any call indication is received (RING, CRING, CLCC, and so on). Afterwards, <mode> stored in MS non-volatile memory, returns to be effective.

If CSNS set command is issued in conjunction with <repeated> value ’1’, then selected CSNS <mode> is effective until new CSNS set command is issued or until next power cycle.

If CSNS set command is issued without parameter <repeated>, the value of repeated is assumed to be ’0’.

April 15, 2008 G24-L AT Commands Reference Manual 3-35