PIONEERPOS G24-L Result Code Selection and Call Progress Monitoring Control, X Parameters, Atx?

Chapter 3: AT Commands Reference

Example

ATE?

001 OK

X, Result Code Selection and Call Progress Monitoring Control

This command defines the CONNECT result code format. It determines whether or not the

G24-L transmits particular result codes to the user. It also controls whether the G24-L verifies the presence of dial tone when it first goes off-hook to begin dialing, and whether the engaged tone (busy signal) detection is enabled.

Command Type	Syntax	Response/Action	Remarks
Set	ATX<value>	OK	The Set command sets the result code
		or:	and call progress monitoring control.
		+CME ERROR: <err>
Read	ATX?	<current value>
Test			The Test command for X is not defined
			by ITU, and therefore is not supported
			by the G24-L. The G24-L returns an
			error.

The following table shows the X parameters.

		Table 3-130: X Parameters
<Parameter>		Description
<value>	0	CONNECT result code given upon entering online data state:
		Dial tone detection - Disabled
		Busy detection - Disabled
	1	CONNECT <text> result code given upon entering online data state:
		Dial tone detection - Disabled
		Busy detection - Disabled
	2	CONNECT <text> result code given upon entering online data state:
		Dial tone detection - Enabled
		Busy detection - Disabled
	3	CONNECT <text> result code given upon entering online data state:
		Dial tone detection - Disabled
		Busy detection - Enabled
	4	CONNECT <text> result code given upon entering online data state:
		Dial tone detection - Enabled
		Busy detection - Enabled
	The default value is 0.

Example

ATX?

000 OK

April 15, 2008 G24-L AT Commands Reference Manual 3-193