PIONEERPOS G24-LC manual At+Mipodm?, +MIPODM 0,0, At+Mipodm=?

GPRS

The +MIPODM command returns a +MIPSTAT <Socket ID><Error> unsolicited event if it fails. For example, if it was rejected by the remote side.

Command Type	Syntax	Response/Action	Remarks
Set	AT+MIPODM=	OK	The Set command returns
	<Socket ID>,	or:	<Remote IP> and
	<Source Port>,	+MIPODM: <Socket	<Remote Port>
			parameters only for
	<Remote IP>,	ID>,<State>[,<Remote IP>,<Remote
			sockets opened in Listen
	<Remote Port>,
		Port>]	mode.
	<Protocol>	or:
		+MIPSTAT: <Socket ID>,<Status>
		or:
		ERROR: <err>
Read	AT+MIPODM?	+MIPODM:[<SocketID>]	When a socket opens in
		for each socket that can be opened	Online Data Mode, the
		or:	command returns actual
			Socket ID value and '1'
		+MIPODM 0,0
			value (active). G24-L
		if there are no free sockets.	will be in
			pseudo-command mode
			for receiving the
			command.
Test	AT+MIPODM=?	+MIPODM: (list of supported
		<socket ID>s),(list of supported
		<source port>s),(list of
		supported<"Destination IP">s),
		(list of <destination port>s),(list of
		supported <protocol>s)

3-280 G24-L AT Commands Reference Manual April 15, 2008