PIONEERPOS G24-LC manual 96 +MIOD Parameters, Keypad GPIOs, Gpio, Pin#

Hardware Information

The following table shows the +MIOD parameters.

		Table 3-96: +MIOD Parameters
<Parameter>		Description
<pin selection>	Selected pins for the action invoked. This is a binary vector in which each bit points to
	pin number. Vector size is 8.
	0	Not selected
	1	Selected pin (default)
<mode>	GPIO pin operation mode.
	0	Output (level only)
	1	Input (level mode)
<mode vector>	This is a binary vector in which each bit shows the operation mode of pin. Data vector
	size is 8.
	0	Output (level only)
	1	Input (level mode)
	The default value:
	On Power Up - as previously saved in FLEX bytes.
	Before set command first used - 1. (This means that all lines are configured as Input
	before set command first used).
<data vector>	This is a binary vector in which each bit shows the physical value of pin. Data vector
	size is 8.
	0	Physical low signal.
	1	Physical high signal (default).
	The default value:
	On Power Up - as previously saved in FLEX bytes.
	Before set command first used with <Data vector> and <Mode>=0, or after +MIOD
	without <Data vector> and before +MIOD command used - 1.

The following table shows the keypad GPIOs.

	Table 3-97: Keypad GPIOs
GPIO		70 PIN	GPIO
		connector,
Name			Number
		PIN#
GPIO1		28	1
GPIO2		30	2
GPIO3		32	3
GPIO4		34	4
GPIO5		36	5
GPIO6		38	6
GPIO7		40	7
GPIO8		42	8

3-148 G24-L AT Commands Reference Manual April 15, 2008