Direct Dialing from Phone Books, D Parameters

The following table shows the D parameters.

	Table 3-4: D Parameters

<Parameter>	Description


<number>	Valid phone digits are: 0 1 2 3 4 5 6 7 8 9 * # + and ,
	The following characters are ignored: A B C D - () / and <space>.
	The comma <,> digit: When dialing a voice call, digits until the comma are
	considered addressing information (phone number). Any digits after the comma are
	sent as DTMF tones after the voice call is connected. More than one comma causes a
	pause in sending the tones. When dialing a data/fax call, the comma digit is ignored,
	and all other digits before and after the comma are considered addressing information
	(phone number).
	The plus <+> digit: Indicates that the international access code exists in the number.

semicolon (;)	When given after <number string>, a voice call is originated to the given address,
	otherwise a data call is originated.

Note: ATDP, ATDT, AT*D, <T>, <P> and <*> are ignored. The command is handled as ATD.

Initiating a GPRS connection is done through ATD*99#, as described in “D*99, Request GPRS Service "D"” on page 3-242.

D>, Direct Dialing from Phone Books

This command places a FAX/DATA/VOICE call on the current network by dialing directly from the G24-L phone book.

Notes:	• "+CME ERROR: not found" is returned when no match is found in an existing
	phone book.
	• FD phone book supports the (?) wild card character. Telephone numbers
	containing this character cannot be dialed directly from the phone book.
	• "+CME ERROR: Invalid index" is returned when entry <n> is out of the
	requested Phonebook range.
	• When SM phonebook is searched and the given entry value is of the ME
	phonebook, ME phonebook will be searched as well (result code would be the
	same as if MT phonebook was searched).

3-12

April 15, 2008